Machining TechTips / Calculators

TechTips · Drilling calculator

Drilling Speed & Feed Calculator

Enter the drill, the surface speed and the feed per revolution. Spindle speed, feed rate, feed per flute, removal rate and cutting time update as you type, in inch or metric.

Inputs

Results update as you type. Fractions like 1/4 or 1-1/8 are accepted.

Spindle speed

—

Enter the drill diameter, surface speed and feed per revolution.

Feed rate
—
Feed per flute
—
Removal rate
—
Cutting time per hole
—

Starting surface speeds for solid carbide drills

Use these as a first setting, then adjust for rigidity, coolant delivery and hole depth. Feed per revolution scales with diameter: a common starting point is roughly 1% of drill diameter in steel. Pick a material to load the middle of its range.

MaterialSFMm/minNotesUse
Aluminum & non-ferrous300 – 60090 – 180Watch chip packing; peck on deep holes
Low carbon steel (1018)200 – 35060 – 105Through-coolant helps above 3×D
Alloy steel (4140)150 – 25045 – 75Rigid setup matters more than speed
Stainless (304 / 316)100 – 18030 – 55Keep feeding; dwelling work-hardens the hole
Cast iron200 – 35060 – 105Abrasive dust; air blast if running dry
Titanium (Ti-6Al-4V)60 – 12018 – 36Heat stays in the tool; flood coolant
Inconel & HRSA30 – 609 – 18Short, rigid drills only

Make the hole

The numbers only hold if the drill does. Solid carbide drills ground for round, on-size holes.

How the drilling formulas work

Formulas (inch)

  • RPM = SFM × 12 ÷ (π × D)
  • IPM = IPR × RPM
  • Feed per flute = IPR ÷ flutes
  • MRR (in³/min) = (π ÷ 4) × D² × IPM
  • Cutting time (s) = hole depth ÷ IPM × 60

Formulas (metric)

  • n (RPM) = Vc × 1000 ÷ (π × D)
  • Vf (mm/min) = fn × n
  • fz = fn ÷ flutes
  • Q (cm³/min) = (π ÷ 4) × D² × Vf ÷ 1000

Cycle time is cutting time only. It does not include rapid approach, peck retracts or dwell. Removal rate assumes a full-diameter hole in solid material. All figures are theoretical starting points; confirm against your machine, holder and coolant setup. Need a tap drill instead? Use the Tap Drill Calculator.