3/32" End Mill Single End Square. Stub Length. Flute Length 3/16" OAL 1-1/2" - 3 Flutes TiCN Coated

3/32" End Mill Single End Square. Stub Length. Flute Length 3/16" OAL 1-1/2" - 3 Flutes TiCN Coated

End Mill
$5.33 each
Item #
Series
Coating
Quantity
- +

3/32" cutting diameter, 3 flutes, single end, square end, stub length, TiCN coated.

Ground from solid carbide. This tool cuts 3/32" diameter, has 3/16" of flute and measures 1-1/2" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The stub length keeps the tool short and stiff, which is where you get the least deflection and the best finish.

TiCN is harder than TiN and holds up better in abrasive materials and higher feeds.

Specifications

  • Cutting diameter: 3/32"
  • Length of cut (LOC): 3/16"
  • Overall length (OAL): 1-1/2"
  • Flutes: 3
  • End type: Single End
  • End geometry: Square End
  • Length style: Stub
  • Coating: TiCN
  • Tool material: Solid Carbide
  • Series: 111
  • Item number: 111-3093

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide