15/64" End Mill Single End Square. Flute Length 3/4" - OAL 2-1/2" - 2 Flutes TiCN Coated

15/64" End Mill Single End Square. Flute Length 3/4" - OAL 2-1/2" - 2 Flutes TiCN Coated

End Mill
$15.32 each
Item #
Series
Coating
Quantity
- +

15/64" cutting diameter, 2 flutes, single end, square end, TiCN coated.

Ground from solid carbide. This tool cuts 15/64" diameter, has 3/4" of flute and measures 2-1/2" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

TiCN is harder than TiN and holds up better in abrasive materials and higher feeds.

Specifications

  • Cutting diameter: 15/64"
  • Length of cut (LOC): 3/4"
  • Overall length (OAL): 2-1/2"
  • Flutes: 2
  • End type: Single End
  • End geometry: Square End
  • Coating: TiCN
  • Tool material: Solid Carbide
  • Series: 127
  • Item number: 127-2234

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide