1-1/4" Solid Carbide End Mill Single End Square. Long. Shank OD 1-1/4", Flute Length 2-1/4", OAL 5'' - 2 Flutes Sky Coat
1-1/4" Solid Carbide End Mill Single End Square. Long. Shank OD 1-1/4", Flute Length 2-1/4", OAL 5'' - 2 Flutes Sky Coat
1-1/4" Solid Carbide End Mill Single End Square. Long. Shank OD 1-1/4", Flute Length 2-1/4", OAL 5'' - 2 Flutes Sky Coat
1-1/4" Solid Carbide End Mill Single End Square. Long. Shank OD 1-1/4", Flute Length 2-1/4", OAL 5'' - 2 Flutes Sky Coat

1-1/4" Solid Carbide End Mill Single End Square. Long. Shank OD 1-1/4", Flute Length 2-1/4", OAL 5'' - 2 Flutes Sky Coat

End Mill
$792.26 each
Item #
Series
Coating
Quantity
- +

1-1/4" cutting diameter, 2 flutes, single end, square end, Sky Coat coated.

Ground from solid carbide. This tool cuts 1-1/4" diameter, runs a 1-1/4" shank, has 2-1/4" of flute and measures 5" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The Sky Coat finish is intended to support lubricity and wear resistance in milling applications.

Specifications

  • Cutting diameter: 1-1/4"
  • Shank diameter: 1-1/4"
  • Length of cut (LOC): 2-1/4"
  • Overall length (OAL): 5"
  • Flutes: 2
  • End type: Single End
  • End geometry: Square End
  • Coating: Sky Coat
  • Tool material: Solid Carbide
  • Series: 161
  • Item number: 161-2108

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide