5/16" Solid Carbide End Mill Single End Square. Long. Shank OD 5/16", Flute Length 1-1/8", OAL 3'' - 2 Flutes Sky Coat
5/16" Solid Carbide End Mill Single End Square. Long. Shank OD 5/16", Flute Length 1-1/8", OAL 3'' - 2 Flutes Sky Coat
5/16" Solid Carbide End Mill Single End Square. Long. Shank OD 5/16", Flute Length 1-1/8", OAL 3'' - 2 Flutes Sky Coat
5/16" Solid Carbide End Mill Single End Square. Long. Shank OD 5/16", Flute Length 1-1/8", OAL 3'' - 2 Flutes Sky Coat

5/16" Solid Carbide End Mill Single End Square. Long. Shank OD 5/16", Flute Length 1-1/8", OAL 3'' - 2 Flutes Sky Coat

End Mill
$26.02 each
Item #
Series
Coating
Quantity
- +

5/16" cutting diameter, 2 flutes, single end, square end, Sky Coat coated.

Ground from solid carbide. This tool cuts 5/16" diameter, runs a 5/16" shank, has 1-1/8" of flute and measures 3" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The Sky Coat finish is intended to support lubricity and wear resistance in milling applications.

Specifications

  • Cutting diameter: 5/16"
  • Shank diameter: 5/16"
  • Length of cut (LOC): 1-1/8"
  • Overall length (OAL): 3"
  • Flutes: 2
  • End type: Single End
  • End geometry: Square End
  • Coating: Sky Coat
  • Tool material: Solid Carbide
  • Series: 161
  • Item number: 161-2312

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide