1/8" Solid Carbide End Mill Single End Square. Double End Stub Length. Shank OD 1/8", Flute Length 1/4", OAL 1-1/2'' - 4 Flutes Sky Coat
1/8" Solid Carbide End Mill Double End Square. Stub Length. Shank OD 1/8", Flute Length 1/4", OAL 1-1/2'' - 4 Flutes Sky Coat
1/8" Solid Carbide End Mill Single End Square. Double End Stub Length. Shank OD 1/8", Flute Length 1/4", OAL 1-1/2'' - 4 Flutes Sky Coat
1/8" Solid Carbide End Mill Double End Square. Stub Length. Shank OD 1/8", Flute Length 1/4", OAL 1-1/2'' - 4 Flutes Sky Coat

1/8" Solid Carbide End Mill Double End Square. Stub Length. Shank OD 1/8", Flute Length 1/4", OAL 1-1/2'' - 4 Flutes Sky Coat

Solid Carbide Square End Mill
$9.44 each
Item #
Series
Coating
Quantity
- +

1/8" cutting diameter, 4 flutes, double end, square end, double end stub length, Sky Coat coated.

Ground from solid carbide. This tool cuts 1/8" diameter, runs a 1/8" shank, has 1/4" of flute and measures 1-1/2" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

Double ended and stub length: two cutting ends on one short, rigid body.

The Sky Coat finish is intended to support lubricity and wear resistance in milling applications.

Specifications

  • Cutting diameter: 1/8"
  • Shank diameter: 1/8"
  • Length of cut (LOC): 1/4"
  • Overall length (OAL): 1-1/2"
  • Flutes: 4
  • End type: Double End
  • End geometry: Square End
  • Length style: Double End Stub
  • Coating: Sky Coat
  • Tool material: Solid Carbide
  • Series: 203
  • Item number: 203-4125

Availability and Shipping

For HTC carbide tools, coating service typically adds 2–3 calendar days when the uncoated tool is available. If the tool is not in stock, estimated time to ship is 7–10 calendar days.

Estimated time to ship is measured in calendar days, from order placement until your order is handed to the carrier. Carrier transit time is additional. Orders may ship sooner. We accept orders awaiting replenishment; please contact us before ordering if you need a specific shipping date.

See our Shipping Policy for details.

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide