9/16" End Mill Double End Square. W/Weldon Flats. Flute Length 1-1/4" OAL 5" - 4 Flutes - Uncoated
9/16" End Mill Double End Square. W/Weldon Flats. Flute Length 1-1/4" OAL 5" - 4 Flutes - Uncoated
9/16" End Mill Double End Square. W/Weldon Flats. Flute Length 1-1/4" OAL 5" - 4 Flutes - Uncoated
9/16" End Mill Double End Square. W/Weldon Flats. Flute Length 1-1/4" OAL 5" - 4 Flutes - Uncoated

9/16" End Mill Double End Square. W/Weldon Flats. Flute Length 1-1/4" OAL 5" - 4 Flutes - Uncoated

End Mill
$60.39 each
Item #
Series
Coating

9/16" cutting diameter, 4 flutes, double end, square end, uncoated.

Ground from solid carbide. This tool cuts 9/16" diameter, has 1-1/4" of flute and measures 5" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The Weldon flats give the holder a positive grip so the tool cannot pull out under load.

Uncoated, so the edge stays as sharp as it can be ground — the usual choice for aluminium and other soft, sticky materials.

Specifications

  • Cutting diameter: 9/16"
  • Length of cut (LOC): 1-1/4"
  • Overall length (OAL): 5"
  • Flutes: 4
  • End type: Double End
  • End geometry: Square End
  • Shank: Weldon flats
  • Coating: Uncoated
  • Tool material: Solid Carbide
  • Series: 210
  • Item number: 210-4532

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide