5/32" End Mill Double End Square. W/Weldon Flats. Flute Length 7/16" OAL 3-1/8" - 4 Flutes - AlTiN Coated
5/32" End Mill Double End Square. W/Weldon Flats. Flute Length 7/16" OAL 3-1/8" - 4 Flutes - AlTiN Coated
5/32" End Mill Double End Square. W/Weldon Flats. Flute Length 7/16" OAL 3-1/8" - 4 Flutes - AlTiN Coated
5/32" End Mill Double End Square. W/Weldon Flats. Flute Length 7/16" OAL 3-1/8" - 4 Flutes - AlTiN Coated

5/32" End Mill Double End Square. W/Weldon Flats. Flute Length 7/16" OAL 3-1/8" - 4 Flutes - AlTiN Coated

End Mill
$31.08 each
Item #
Series
Coating
Quantity
- +

5/32" cutting diameter, 4 flutes, double end, square end, AlTiN coated.

Ground from solid carbide. This tool cuts 5/32" diameter, has 7/16" of flute and measures 3-1/8" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The Weldon flats give the holder a positive grip so the tool cannot pull out under load.

AlTiN is built for heat: stainless, tool steels and high-temperature alloys, especially with little or no coolant.

Specifications

  • Cutting diameter: 5/32"
  • Length of cut (LOC): 7/16"
  • Overall length (OAL): 3-1/8"
  • Flutes: 4
  • End type: Double End
  • End geometry: Square End
  • Shank: Weldon flats
  • Coating: AlTiN
  • Tool material: Solid Carbide
  • Series: 212
  • Item number: 212-4156

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide