1/2" End Mill Double End Ball. W/Weldon Flats. Flute Length 1" OAL 4" - 4 Flutes - AlTiN Coated
1/2" End Mill Double End Ball. W/Weldon Flats. Flute Length 1" OAL 4" - 4 Flutes - AlTiN Coated
1/2" End Mill Double End Ball. W/Weldon Flats. Flute Length 1" OAL 4" - 4 Flutes - AlTiN Coated
1/2" End Mill Double End Ball. W/Weldon Flats. Flute Length 1" OAL 4" - 4 Flutes - AlTiN Coated

1/2" End Mill Double End Ball. W/Weldon Flats. Flute Length 1" OAL 4" - 4 Flutes - AlTiN Coated

End Mill
$78.71 each
Item #
Series
Coating
Quantity
- +

1/2" cutting diameter, 4 flutes, double end, ball nose, AlTiN coated.

Ground from solid carbide. This tool cuts 1/2" diameter, has 1" of flute and measures 4" overall.

The ball nose leaves a radiused bottom, which is what you want for 3D contours, fillets and mould surfaces rather than flat floors.

The Weldon flats give the holder a positive grip so the tool cannot pull out under load.

AlTiN is built for heat: stainless, tool steels and high-temperature alloys, especially with little or no coolant.

Specifications

  • Cutting diameter: 1/2"
  • Length of cut (LOC): 1"
  • Overall length (OAL): 4"
  • Flutes: 4
  • End type: Double End
  • End geometry: Ball Nose
  • Shank: Weldon flats
  • Coating: AlTiN
  • Tool material: Solid Carbide
  • Series: 217
  • Item number: 217-4500

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide