9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated — HTC Mfg.
9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated
9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated
9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated — HTC Mfg.
9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated
9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated

9/16'' End Mill Single End Square. Corner Radius .125" - Shank OD 9/16" Flute Length 1-1/4" OAL 3-1/2" - 2 Flutes - Uncoated

End Mill
$50.40 each
Item #
Series
Coating

9/16" cutting diameter, 2 flutes, single end, corner radius, uncoated.

Ground from solid carbide. This tool cuts 9/16" diameter, runs a 9/16" shank, has 1-1/4" of flute and measures 3-1/2" overall.

The corner radius takes the load off the weakest point of the tool, so the edge lasts longer than a sharp corner in the same cut.

Uncoated, so the edge stays as sharp as it can be ground — the usual choice for aluminium and other soft, sticky materials.

Specifications

  • Cutting diameter: 9/16"
  • Shank diameter: 9/16"
  • Length of cut (LOC): 1-1/4"
  • Overall length (OAL): 3-1/2"
  • Flutes: 2
  • End type: Single End
  • End geometry: Corner Radius
  • Coating: Uncoated
  • Tool material: Solid Carbide
  • Series: 350
  • Item number: 350-2562-125

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide