21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated — HTC Mfg.
21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated
21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated
21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated — HTC Mfg.
21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated
21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated

21/32'' End Mill Single End Square. Corner Radius .090" - Shank OD 3/4" Flute Length 1-1/2" OAL 4" - 2 Flutes - Uncoated

End Mill
$82.38 each
Item #
Series
Coating

21/32" cutting diameter, 2 flutes, single end, corner radius, uncoated.

Ground from solid carbide. This tool cuts 21/32" diameter, runs a 3/4" shank, has 1-1/2" of flute and measures 4" overall.

The corner radius takes the load off the weakest point of the tool, so the edge lasts longer than a sharp corner in the same cut.

Uncoated, so the edge stays as sharp as it can be ground — the usual choice for aluminium and other soft, sticky materials.

Specifications

  • Cutting diameter: 21/32"
  • Shank diameter: 3/4"
  • Length of cut (LOC): 1-1/2"
  • Overall length (OAL): 4"
  • Flutes: 2
  • End type: Single End
  • End geometry: Corner Radius
  • Coating: Uncoated
  • Tool material: Solid Carbide
  • Series: 350
  • Item number: 350-2656-090

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide