11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated — HTC Mfg.
11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated
11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated
11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated — HTC Mfg.
11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated
11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated

11/32" End Mill Single End Square. Corner Radius .125" - Shank OD 3/8'' Flute Length 7/8" OAL 2-1/2" - 2 Flutes - AlTiN Coated

End Mill
$21.58 each
Item #
Series
Coating

11/32" cutting diameter, 2 flutes, single end, corner radius, AlTiN coated.

Ground from solid carbide. This tool cuts 11/32" diameter, runs a 3/8" shank, has 7/8" of flute and measures 2-1/2" overall.

The corner radius takes the load off the weakest point of the tool, so the edge lasts longer than a sharp corner in the same cut.

AlTiN is built for heat: stainless, tool steels and high-temperature alloys, especially with little or no coolant.

Specifications

  • Cutting diameter: 11/32"
  • Shank diameter: 3/8"
  • Length of cut (LOC): 7/8"
  • Overall length (OAL): 2-1/2"
  • Flutes: 2
  • End type: Single End
  • End geometry: Corner Radius
  • Coating: AlTiN
  • Tool material: Solid Carbide
  • Series: 360
  • Item number: 360-2343-125

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide