3/16" OD x 3/8" Shank OD x 3/8" LOC x 2-5/16" OAL 2-Flute Single End High-Speed Steel (HSS) Finishing End Mill, 30° Helix, Center Cut, Square End, Regular Length, Bright Finish (Uncoated).
This 2-flute high-speed steel (hss) finishing end mill uses a 30° helix and regular length construction for accurate, controlled milling. The square-end geometry is suited to finishing slots, pockets, shoulders, side walls, and flat-bottom features. The center-cutting geometry also supports controlled axial entry, ramping, and pocketing when appropriate for the workpiece and setup. The standard finishing geometry is intended for controlled sizing and surface-finish passes.
High-speed steel provides toughness and resistance to chipping for general machining, repair work, interrupted cuts, and setups that benefit from a forgiving cutting edge.
The bright, uncoated finish provides a direct cutting edge for general finishing where an added coating is not required.
If an HTC HSS or cobalt tool is not in stock, estimated time to ship is 10–15 calendar days.
Estimated time to ship is measured in calendar days, from order placement until your order is handed to the carrier. Carrier transit time is additional. Orders may ship sooner. We accept orders awaiting replenishment; please contact us before ordering if you need a specific shipping date.
See our Shipping Policy for details.
Free TechTips resources for end mill users — machinist tested.
More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide
