SIMWLNL 12-3 — boring bar, 0.75" bar diameter, 1.000" minimum bore, 10.0" overall length. Made in the USA by RMC Tooling.
-5° End & Side Cutting Edge Angle for Negative Trigon WNM_ Inserts.
Steel-shank indexable boring bar from RMC Tooling, machined in the United States. Ground shank, standard indexable geometry, and a rigid clamping system sized to the bar diameter — the combination that keeps chatter down at the depths where boring bars usually give up.
Sized by minimum bore, so start there: pick the largest bar diameter your bore will clear. Every clamp, lock pin, seat and screw in this bar is a stocked RMC service part, listed below.
These are the service parts RMC lists for this exact model — not a generic cross-reference. Every one is stocked.
| Insert | WNM_-332 (e.g. WNMG 332) — 3/8" I.C. · 3/16" thick · 1/32" nose radius |
| Lock pin | NL-33L |
| Clamp | HC-7 |
| Clamp screw | SHC-7 |
See all RMC spare parts & hardware →
Not sure how to read an insert code? Turning insert designation explained.
Dimensions as published in the RMC 2020 catalog, page 52.
