1/8" End Mill Single End Square. Stub Length. Flute Length 1/4" OAL 1-1/2" - 4 Flutes Sky Coated General Purpose

1/8" End Mill Single End Square. Stub Length. Flute Length 1/4" OAL 1-1/2" - 4 Flutes Sky Coated General Purpose

End Mill
$6.33 each
Item #
Series
Coating
Quantity
- +

1/8" cutting diameter, 4 flutes, single end, square end, stub length.

Ground from solid carbide. This tool cuts 1/8" diameter, has 1/4" of flute and measures 1-1/2" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The stub length keeps the tool short and stiff, which is where you get the least deflection and the best finish.

Specifications

  • Cutting diameter: 1/8"
  • Length of cut (LOC): 1/4"
  • Overall length (OAL): 1-1/2"
  • Flutes: 4
  • End type: Single End
  • End geometry: Square End
  • Length style: Stub
  • Tool material: Solid Carbide
  • Series: 113
  • Item number: 113-4125

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide