7/16" Solid Carbide End Mill Single End Square. Long. Shank OD 7/16", Flute Length 2", OAL 4'' - 4 Flutes Sky Coat
7/16" Solid Carbide End Mill Single End Square. Long. Shank OD 7/16", Flute Length 2", OAL 4'' - 4 Flutes Sky Coat
7/16" Solid Carbide End Mill Single End Square. Long. Shank OD 7/16", Flute Length 2", OAL 4'' - 4 Flutes Sky Coat
7/16" Solid Carbide End Mill Single End Square. Long. Shank OD 7/16", Flute Length 2", OAL 4'' - 4 Flutes Sky Coat

7/16" Solid Carbide End Mill Single End Square. Long. Shank OD 7/16", Flute Length 2", OAL 4'' - 4 Flutes Sky Coat

End Mill
$41.90 each
Item #
Series
Coating

7/16" cutting diameter, 4 flutes, single end, square end, Sky Coat coated.

Ground from solid carbide. This tool cuts 7/16" diameter, runs a 7/16" shank, has 2" of flute and measures 4" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

The Sky Coat finish is intended to support lubricity and wear resistance in milling applications.

Specifications

  • Cutting diameter: 7/16"
  • Shank diameter: 7/16"
  • Length of cut (LOC): 2"
  • Overall length (OAL): 4"
  • Flutes: 4
  • End type: Single End
  • End geometry: Square End
  • Coating: Sky Coat
  • Tool material: Solid Carbide
  • Series: 161
  • Item number: 161-4347

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide