7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated
7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated

7/8" End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated

End Mill
$209.68 each
Item #
Series
Coating
Quantity
- +

7/8" Solid Carbide End Mill Single End Square. Shank OD 7/8" Flute Length 1-1/2" OAL 4" - 6 Flutes - Uncoated -

General Purpose

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide