31/64" End Mill Single End Square. Flute Length 1" - OAL 3" - 3 Flute. Uncoated

31/64" End Mill Single End Square. Flute Length 1" - OAL 3" - 3 Flute. Uncoated

Solid Carbide Square End Mill
$34.20 each
Item #
Series
Coating
Quantity
- +

31/64" cutting diameter, 3 flutes, single end, square end, uncoated.

Ground from solid carbide. This tool cuts 31/64" diameter, has 1" of flute and measures 3" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

Uncoated, so the edge stays as sharp as it can be ground — the usual choice for aluminum and other soft, sticky materials.

Specifications

  • Cutting diameter: 31/64"
  • Length of cut (LOC): 1"
  • Overall length (OAL): 3"
  • Flutes: 3
  • End type: Single End
  • End geometry: Square End
  • Coating: Uncoated
  • Tool material: Solid Carbide
  • Series: 120
  • Item number: 120-3484

Availability and Shipping

For HTC carbide tools, coating service typically adds 2–3 calendar days when the uncoated tool is available. If the tool is not in stock, estimated time to ship is 7–10 calendar days.

Estimated time to ship is measured in calendar days, from order placement until your order is handed to the carrier. Carrier transit time is additional. Orders may ship sooner. We accept orders awaiting replenishment; please contact us before ordering if you need a specific shipping date.

See our Shipping Policy for details.

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide