4 Flute-Extra Long Length-Single End Ball-BRITE - 1-1/4 X 1-1/4 X 4 X 7 — HTC Mfg.
HTC Mfg. End Mill generic category product image
4 Flute-Extra Long Length-Single End Ball-BRITE - 1-1/4 X 1-1/4 X 4 X 7 — HTC Mfg.
HTC Mfg. End Mill generic category product image

4 Flute-Extra Long Length-Single End Ball-BRITE - 1-1/4 X 1-1/4 X 4 X 7 - HTC 175-4110

End Mill
$1,485.36 each
Item #

4 flutes, single end, ball nose, extra long length, bright finish, uncoated.

The ball nose leaves a radiused bottom, which is what you want for 3D contours, fillets and mould surfaces rather than flat floors.

The extra length reaches into deep pockets and past fixturing that a standard tool cannot clear.

The bright, uncoated finish gives a direct cutting edge with no added edge radius from a coating.

Specifications

  • Flutes: 4
  • End type: Single End
  • End geometry: Ball Nose
  • Length style: Extra Long
  • Coating: Bright finish (uncoated)
  • Series: 175
  • Item number: 175-4110

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide