1-3/16" End Mill Single End Square. Roughing "HOG" Turbo Mill. Shank OD 1" Flute Length 1-1/2" OAL 4" - 5 Flutes - Uncoated

1-3/16" cutting diameter, 5 flutes, single end, square end, uncoated.

This tool cuts 1-3/16" diameter, runs a 1" shank, has 1-1/2" of flute and measures 4" overall.

The square end cuts a flat floor with a sharp corner — slots, pockets, shoulders and side milling.

This is a rougher: the chip-breaking edge form cuts the cutting pressure and breaks the chip into short pieces, so it removes stock faster than a finishing tool at the same power.

Uncoated, so the edge stays as sharp as it can be ground — the usual choice for aluminium and other soft, sticky materials.

Specifications

• Cutting diameter: 1-3/16"
• Shank diameter: 1"
• Length of cut (LOC): 1-1/2"
• Overall length (OAL): 4"
• Flutes: 5
• End type: Single End
• End geometry: Square End
• Cutting style: Roughing / chip-breaking
• Coating: Uncoated
• Series: 300
• Item number: 300-5113