1-3/16" End Mill S.E. Sq. Roughing "HOG" Turbo Mill. Shank OD 1" Flute Length 1-1/2" OAL 4" - 5 Flutes - TiCN Coated
1-3/16" End Mill S.E. Sq. Roughing "HOG" Turbo Mill. Shank OD 1" Flute Length 1-1/2" OAL 4" - 5 Flutes - TiCN Coated
1-3/16" End Mill S.E. Sq. Roughing "HOG" Turbo Mill. Shank OD 1" Flute Length 1-1/2" OAL 4" - 5 Flutes - TiCN Coated
1-3/16" End Mill S.E. Sq. Roughing "HOG" Turbo Mill. Shank OD 1" Flute Length 1-1/2" OAL 4" - 5 Flutes - TiCN Coated

1-3/16" End Mill S.E. Sq. Roughing "HOG" Turbo Mill. Shank OD 1" Flute Length 1-1/2" OAL 4" - 5 Flutes - TiCN Coated

End Mill
$337.70 each
Item #
Series
Coating

1-3/16" cutting diameter, 5 flutes, TiCN coated.

Ground from solid carbide. This tool cuts 1-3/16" diameter, runs a 1" shank, has 1-1/2" of flute and measures 4" overall.

This is a rougher: the chip-breaking edge form cuts the cutting pressure and breaks the chip into short pieces, so it removes stock faster than a finishing tool at the same power.

TiCN is harder than TiN and holds up better in abrasive materials and higher feeds.

Specifications

  • Cutting diameter: 1-3/16"
  • Shank diameter: 1"
  • Length of cut (LOC): 1-1/2"
  • Overall length (OAL): 4"
  • Flutes: 5
  • Cutting style: Roughing / chip-breaking
  • Coating: TiCN
  • Tool material: Solid Carbide
  • Series: 307
  • Item number: 307-5113

Recently viewed

Dial In Your Cut

Free TechTips resources for end mill users — machinist tested.

Speeds & Feeds CalculatorsThe right RPM and feed rate for your end mill, material and setup.Open calculator → Chip Load (FPT) CalculatorFeed per tooth keeps carbide cutting instead of rubbing — with chip thinning compensation.Open calculator → MRR CalculatorHow hard your end mill is really working, and where your cycle time goes.Open calculator →

More help: Milling TechTips · Troubleshooting · Carbide vs. HSS Guide