1-1/2" OD x 1-1/4" Shank OD x 3" LOC x 5-1/2" OAL 2-Flute SE HSS Finishing End Mill 37° H CC SQ Long Aluminum Bright (Uncoated) EDP #12068

1-1/2" OD x 1-1/4" Shank OD x 3" LOC x 5-1/2" OAL 2-Flute Single End High-Speed Steel (HSS) Finishing End Mill, 37° Helix, Center Cut, Square End, Long Length, Aluminum-Cutting Geometry, Bright Finish (Uncoated).

This 2-flute high-speed steel (hss) finishing end mill uses a 37° helix and long length construction for accurate, controlled milling. The square-end geometry is suited to finishing slots, pockets, shoulders, side walls, and flat-bottom features. The center-cutting geometry also supports controlled axial entry, ramping, and pocketing when appropriate for the workpiece and setup. This tool is identified in the source specification as Aluminum-Cutting Geometry.

High-speed steel provides toughness and resistance to chipping for general machining, repair work, interrupted cuts, and setups that benefit from a forgiving cutting edge.

The bright, uncoated finish provides a direct cutting edge for general finishing where an added coating is not required.

Specifications

• Cutting diameter: 1-1/2"
• Shank diameter: 1-1/4"
• Length of cut (LOC): 3"
• Overall length (OAL): 5-1/2"
• Flutes: 2
• End type: Single End
• End geometry: Square End
• Cutting style: Finishing
• Helix angle: 37°
• Center cutting: Yes
• Length style: Long Length
• Coating: Bright Finish (Uncoated)
• Material: High-Speed Steel (HSS)
• Special features: Aluminum-Cutting Geometry
• EDP number: 12068
• Item number: AL-48A