3" OD x 2-1/2" Shank OD x 4" LOC x 7-5/8" OAL 8-Flute SE HSS Finishing End Mill 30° H NC SQ Standard Positive-Lock Bright (Uncoated) EDP #33510

3" OD x 2-1/2" Shank OD x 4" LOC x 7-5/8" OAL 8-Flute Single End High-Speed Steel (HSS) Finishing End Mill, 30° Helix, Non-Center Cut, Square End, Standard Length, Positive-Lock Style, Bright Finish (Uncoated).

This 8-flute high-speed steel (hss) finishing end mill uses a 30° helix and standard length construction for accurate, controlled milling. The square-end geometry is suited to finishing slots, pockets, shoulders, side walls, and flat-bottom features. The non-center-cutting geometry is intended for side milling and requires an existing entry path for axial engagement. This tool is identified in the source specification as Positive-Lock Style.

High-speed steel provides toughness and resistance to chipping for general machining, repair work, interrupted cuts, and setups that benefit from a forgiving cutting edge.

The bright, uncoated finish provides a direct cutting edge for general finishing where an added coating is not required.

Specifications

• Cutting diameter: 3"
• Shank diameter: 2-1/2"
• Length of cut (LOC): 4"
• Overall length (OAL): 7-5/8"
• Flutes: 8
• End type: Single End
• End geometry: Square End
• Cutting style: Finishing
• Helix angle: 30°
• Center cutting: No
• Length style: Standard Length
• Coating: Bright Finish (Uncoated)
• Material: High-Speed Steel (HSS)
• Special features: Positive-Lock Style
• EDP number: 33510
• Item number: PLC-96-4