1" OD x 1" Shank OD x 4" LOC x 6-1/2" OAL 3-Flute SE HSS Finishing End Mill 30° H CC SQ Long Bright (Uncoated) EDP #39557

1" OD x 1" Shank OD x 4" LOC x 6-1/2" OAL 3-Flute Single End High-Speed Steel (HSS) Finishing End Mill, 30° Helix, Center Cut, Square End, Long Length, Bright Finish (Uncoated).

This 3-flute high-speed steel (hss) finishing end mill uses a 30° helix and long length construction for accurate, controlled milling. The square-end geometry is suited to finishing slots, pockets, shoulders, side walls, and flat-bottom features. The center-cutting geometry also supports controlled axial entry, ramping, and pocketing when appropriate for the workpiece and setup. The standard finishing geometry is intended for controlled sizing and surface-finish passes.

High-speed steel provides toughness and resistance to chipping for general machining, repair work, interrupted cuts, and setups that benefit from a forgiving cutting edge.

The bright, uncoated finish provides a direct cutting edge for general finishing where an added coating is not required.

Specifications

• Cutting diameter: 1"
• Shank diameter: 1"
• Length of cut (LOC): 4"
• Overall length (OAL): 6-1/2"
• Flutes: 3
• End type: Single End
• End geometry: Square End
• Cutting style: Finishing
• Helix angle: 30°
• Center cutting: Yes
• Length style: Long Length
• Coating: Bright Finish (Uncoated)
• Material: High-Speed Steel (HSS)
• Special features: Standard
• EDP number: 39557
• Item number: SEL-32A